Engine Parts

The component that moves in an alternator, called a rotor, has permanent magnets that rotate around the iron plates of the stator to produce alternating current (AC). Only until the engine or turbine is already operating will a Rotor interact with a...

This product replaces:BRP330081

The Seal - BRP (324639) protects shafts and bearings from dirt and foreign object ingress as well as oil or grease egress. To keep lubricants from seeping out of the seal even while it's under a lot of pressure. This is a high-quality replacement item...

The Gasoline Inline Fuel Filter removes small particles and other pollutants that might block the fuel system. It's critical to keep your fuel system clean, especially on boats with fixed air systems, or you risk attracting fish. WARNING: CA PROPOSITION...

A bush is a mechanical connection between two potentially moving pieces or a solid connection point between two mechanical assemblies. In an automobile or other vehicle, bushings are used to connect the various moving arms and pivot points to the chassis...

This product replaces:765329

A TERMINAL is made to be mounted by being fastened, often at one end, to a post, stud, chassis, or other comparable structure. It provides provisions for the connection of wire(s) or similar electrical conductor(s) to establish an electrical contact,...

This product replaces:BRP313276, BRP332501, 745419257491, 332501, 313276

Shims are used to level, help with, and improve the fit. It is also used on stamped, molded, and worn housings to hold bearings firmly. Shim rings are frequently combined with lock washers or retention rings to prevent axial movement between machine...

When added to fresh fuels, it protects the entire fuel system, conditions it, and extends its useful shelf life. All service and operator manuals promote the use of 2 + 4 fuel conditioner daily, especially while the engine is not in a bottled gas were...

This product replaces:BRP332089, 745419065027, 332089

A pipe fitting known as a pipe Tee is T-shaped and has two outputs at 90° from the connection to the main line. The pipe has a lateral outlet and is only a short piece. Pipe fittings like pipe tees are utilized to carry two-phase fluid mixes across...