Airmar

Thru-hull spares kit. Contains all wearing parts in the paddlewheel assembly Fits: Raymarine ST600, ST700 Contains: 1 paddlewheel and shaft 6 o-rings 1 valve 1 retaining ring

Airmar Standard Fairing Block for B45Model: 33-351-01B45 Standard Fairing Block.Dimensions: 4.25" x 2.37" x 1.87" Tall

Fits: newer style P66 transducers,  Identifier: Horseshoe shaped slot in cover where cable exits. Older style P66 bracket (P/N 20-275-01) is no longer available

Spares kit for S800 and ST800/ Contains all wearing parts in the paddlewheel and blankign plug. 1 - paddlewheel and shaft 2 - O-rings 1 - valve sleeve 1 - retaining ring Note: Not the same as...

Airmar High Speed fairing Block with Hardware for B45Model: 33-509-01B45 High Speed Fairing Block and hardware (33-443-01).Dimensions: 13.75" x 2.56" x 2.94" TallWhat's in the Box:fairing...

Low/High Frequency - In-Hull Chirp Transducer without ConnectorRely on Airmar's new broadband transducers for your ultimate fishing mission. Whether you're a commercial fisherman, charter captain,...

60WR-1 Crows Foot Transducer WrenchTransducer wrenches are available for all bronze low profile transducers. They are used to facilitate holding of the transducer and tightening of the hull nut...

60WR-2 Transducer Hull Nut WrenchA single-handed wrench to tighten the hull nut on 2" bronze and stainless steel housings. You can use wrench 60WR-4 to brace the housing when using this wrench.For...

60WR-3 Double Handle Transducer WrenchTransducer wrenches are available for all bronze low profile transducers. They are used to facilitate holding of the transducer and tightening of the hull nut...

60WR-4 Transducer Housing WrenchA single-handed wrench that holds the main thru-hull housing via the 'wrench flats' on the side of the housing to facilitate tightening of the hull nut.Use wrench...

75WR-1 Crows Foot Transducer WrenchTransducer wrenches are available for all bronze low profile transducers. They are used to facilitate holding of the transducer and tightening of the hull nut...

75WR-2 Transducer Hull Nut WrenchA single-handed wrench to tighten the hull nut on bronze and stainless steel housings. You can use wrench 75WR-4 to brace the housing when using this wrench.For use...