Trim Tabs

MANUAL LEVELING CONTROL (MLC-1)

CONTROL SWITCH With LED TAB Position. (SLC-11)

These sturdy, 12 gauge Standard Stainless Steel T9X30 are part of Lectrotab's electromechanical trim tab system, designed to meet your marine needs, a vital choice to the conventional hydraulic systems. The electric trim tab system presents advantages...

TRIM TAB, STANDARD SST (PAIR) - T9X24 is a metal plate fastened to a boat to the stern's two sides. Trim tab actuators are connected to these plates. The actuators, which help maintain the boat level and even as you go across the water, are controlled...

This product replaces:37100-87J00-0EP, 38100-87J0EP, 47-18304, MV8V1021, 9-18304

Precision engineering creates Lectrotab trim tab actuators, which have a non-hydraulic, maintenance-free design and quiet operation. The unit is completely self-contained for simple installation, ensures extremely accurate tab alignment, and is...

The Lectrotab electromechanical trim tab system, a novel replacement for traditional hydraulic systems, includes these sturdy, 12 gauge 304 stainless steel trim tabs. The electric trim tab system has benefits including drastically shorter installation...

Cobra Trim Sender designed for use and fitting OMC Cobra stern drive located on either side of the gimbal ring. It is a switch used to send a signal to the trim gauge to see the level of the drive. Allows the system to use smaller wires with less power...

This product replaces:435345, 840080476261

FLAT ROCKER SWITCH (SAF-SC)

The trim sender switch sends a signal to the Trim Gauge to check the drive's level. The Trim Limit Switch is a safety feature that prevents the driver from over-trimming. The trim limit (TL) switches positions on the gimbal housing's left side. This...

The MERC POWER TRIM HOSE 18-2111 IS fits all Mercury Mariner power trim equipped in-line motors except models with a power trim pump mounted between the engine clamp brackets. The Trim cylinder to the connector block tilt hose. This power trim hose...