Fuse and Fuse Holders

Blue Sea Systems WeatherDeck® 12V DC Waterproof Switch Panel - 4 PositionModel: 4305-BSSIntegrated switch guards reduce the risk of accidental switchingPanels can be mounted in four different orientationsPanel front rated IP67 when properly mounted...

Blue Sea Systems Weather Deck 12V DC Waterproof Fuse Panel - Gray 2 PositionsModel: 4302-BSSPanel front rated IP67 when properly mounted with watertight mounting gasketIP67 — protected against immersion up to 1 meter for 30 minutesDesigned for...

Blue Sea Systems ST Blade Split Bus Fuse Block 12 CircuitsModel: 5032Provides two isolated groups of six ATO®/ATC® circuitsFor use with either two isolated batteries or with a single battery providing a mix of 24 hour and switched circuitsScrew...

Blue Sea Systems ST Blade Fuse Block - 6 Circuits with Negative Bus and CoverModel: 5025Positive distribution bus with #10-32 studCan be used for 24-hour circuitsCover satisfies ABYC/USCG requirements for insulation, incorporates an easy to open push...

Blue Sea Systems ST Blade Fuse Block - 12 Circuits with CoverModel: 5029-BSSPositive distribution bus with #10-32 studCan be used for 24-hour circuitsCover satisfies ABYC/USCG requirements for insulation, incorporates an easy to open push button latch...

Blue Sea Systems ST Blade Compact Fuse Blocks - 8 CircuitsModel: 5046-BSSIgnition protected when cover is secure —meets ISO 8846 and SAE J1171 for use in a gasoline engine compartmentSingle side design allows wire entry from one side to minimize...

BEP Class T Fuse HolderModel: 778-2TS-400Radiused ends improve cable routing optionsClass-T: 225-400 Amp, 450-600 Amp models availableProviding high-capacity fusing, fast response and very high interrupt ratings (ANL up to 6,000 Amps, Class-T up to...

BEP 778-ANL2S 35-750A ANL Fuse HolderModel: 778-ANL2SRadiused ends improve cable routing optionsfor use with 5/16" (8mm) or 3/8" (10mm) ANL fusesHigh temperature, fibre reinforced plastic base provides strength and chemical resistanceClear polycarbonate...

BEP 400 Amp Class T FuseModel: FT-400-BThese corrosion resistant fuses are time delayed to allow temporary harmless in-rush currents to pass, but open quickly on sustained overloads to protect circuits from overloads and short circuits. Each fuse is...

BEP 350 Amp Class T FuseModel: FT-350-BThese corrosion resistant fuses are time delayed to allow temporary harmless in-rush currents to pass, but open quickly on sustained overloads to protect circuits from overloads and short circuits. Each fuse is...

BEP 300 Amp Class T FuseModel: FT-300-BThese corrosion resistant fuses are time delayed to allow temporary harmless in-rush currents to pass, but open quickly on sustained overloads to protect circuits from overloads and short circuits. Each fuse is...

BEP 250 Amp Class T FuseModel: FT-250-BThese corrosion resistant fuses are time delayed to allow temporary harmless in-rush currents to pass, but open quickly on sustained overloads to protect circuits from overloads and short circuits. Each fuse is...